Packing; Transport And Movement; Storage; Installation - Sencotel 121c Manual De Empleo

4.1. Packing

The machine is sent ready for use, packed in a cardboard box.
This cardboard box is made up of a base and a cover, held in
place with two strips of nylon.
PAKING DIMENSION AND WEIGHT
Length (L) Profundity (P)
mm
121c 290
Note: the dimensions and weight of the
packaging are representative values.

4.2. Transport and movement

Ensure that there is no-one in the range of
the lifting and moving of the load and in
difficult circumstances the movement should
be supervised by competent personnel.
The manual movement of the machine should be done by at
least two persons.
The machine should be moved in an upright position.
Lift the package and transport it with care, avoiding accidental
movements and paying attention to its dimension and possible
out jutting objects.
Any produce inside the machine must be removed before
it is moved.
It is forbidden to perform additional cuts on
the packaging.
Damages caused to the machine during transport and
movement are not covered by the GUARANTEE. Repair or
replacement of damaged parts is the sole responsibility of the
Customer.

4.3. Storage

Before storing the machine and before using
a machine that has been stored for a long
period of time, it must be well cleaned
and sanitized.
Warning: do not pile the machines during storage.
9
Weig
Height (H)
mm mm
580 870
In the case of long periods of inactivity the machine must be
stored with precaution regarding the place and the storage
time:
• Store the machine in an enclosed area.
• Protect the machine against shocks and stresses.
• Protect the machine against dampness and large oscillations
in temperature.
• Avoid contact of the machine with corrosive substances.
ht
kg
88

5. INSTALLATION

All operations described in Chapter 4 are to
be exclusively performed by specialized
technicians. These operational sequences
must be planned using suitable means which
respect the regulations applicable for the
material in question.
The machine must be installed inside a building with lighting,
air, and a solid stable and level floor (inclination lower than 2º).
The apparatus must be monitored and should
be installed in places where it can be
observed by trained personnel.
Warning: it is forbidden to install the machine
in places where it can be reached, touched
and/or turned on by persons other than those
specified in section 1.2.
The machine must operate in environments with a temperature
between 25 and 32 ºC.

5.1. List of included accessories

The following material is delivered with the machine:
- n°1, product suction pump kit
- n°3, Air flow regulator
- n°1, O-rings kit
- n°1, Nylon brush
- n°1, Soft-Shake carpilube tube
- n°1, O-ring joint extractor
SL320003270 Ed 03_EN