Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
27. Footswitch (Optional Purchase)
The optional FS-17 footswitch, or any 2-way latching footswitch can be connected
here. The first switch labelled 'Mute' will mute the whole amplifier, and the second
switch labelled 'Reverb' will defeat the reverb on both channels.
28. Power Switch
This switch is used to turn the amplifier on and off.
29. Mains Input
The supplied detachable mains power cable is connected here. Always ensure the
Power Switch (28) is in the OFF position before applying mains power. The cable
should only be connected to a power outlet that is compatible with the voltage,
power and frequency requirements stated on the rear panel. Never break off the
earth (ground) pin on the mains cable. If in doubt seek advice from a qualified
technician.
Tilt-Back and SA-2 Stand Adaptor
30. Tilt-back Stand
On the base of the Sonnet 60, there is a threaded stand socket with an adjustable
tilt-back stand. Rotate the tilt-back stand anti-clockwise to adjust the desired angle
of tilt. Rotate the tilt-back stand clockwise to lower the angle of tilt, or continue
rotating to return the tilt-back stand into the base of the amplifier.
31. SA-2 Stand Adaptor (Optional Purchase)
The optional SA-2 Stand Adaptor can also be mounted on the Sonnet 60, enabling
the amplifier to be placed on a speaker stand. Firstly, remove the tilt-back stand
from the threaded socket then mount the SA-2. Rotate the SA-2 clockwise until it is
flush against the bottom of the amplifier. To remove, rotate the SA-2 anti-clockwise.
WARNING! Ensure the SA-2 is securely mounted to the base of the Sonnet 60
before placing on a speaker stand. Failure to do so may result in unnecessary stress
being placed on the threaded socket and may cause damage to the structure of
the amplifier.
13
Technical Specification
Sonnet 60
Power: 60 Watts
Weight (kg): 7.7
Dimensions (mm): 345mm (W) x 310mm (H) x 250mm (D)
Footswitch (not supplied): FS-17 latching footswitch
Speakers: 1 x Custom Designed Tweeter, 1 x Custom Designed 6.5" Speaker
(Natural 60 - 4ohms)
Specification
Channel 1
>10MΩ
1/4" Input Impedance:
Shape:
+3dB @ 120Hz
-7dB @ 1kHz
+3dB @ 10kHz
Low:
+/-10dB @ 80Hz
+/-10dB @ 700Hz
Mid:
High:
+/-10dB @ 10kHz
Channel 2
1/4" Input Impedance:
1MΩ
1.4kΩ (Balanced)
XLR Input Impedance:
Shape:
+3dB @ 120Hz
-7dB @ 1kHz
+3dB @ 10kHz
Low:
+/-10dB @ 80Hz
+/-10dB @ 10kHz
High:
Global
High Pass Filter:
-6dB @ 27Hz (Min) to 175Hz (Max)
Brilliance:
+/-12dB @ 16kHz
100kΩ
Line In Impedance:
D.I. Output Impedance:
>1kΩ
14
Publicidad
Tabla de contenido
