Powis Fastback 25 Manual Del Usuario página 18

TRO UB LESH OOT ING
VII
Cleaning the Bottom of the Platen
Sometimes the bottom edge of the rotating platen gets
adhesive on it . To reach it, use the small pulley next to the
black gear .
d . With your left hand, rotate the pulley toward the back of the
binder—in a counter-clockwise direction (figure 49) . As you
turn the pulley, the platen rotates .
e . Stop turning when the platen's edge has rotated 90 degrees .
• If the platen is hot, put on the heat-protective glove and
wipe the platen with a clean dry cotton cloth . Wipe the surface
9
F I G U R E
lengthwise until it's clean .
NOTE: Do not use the Citrus solution on the platen when the
platen is hot!
• If the unit has cooled, wipe the platen with a cloth dampened
by Citrus . You can also peel the adhesive off the platen with
your fingers (or a wooden instrument, like an ice cream stick) .
Closing the Fastback® Cover
First, put the book rest back into its original position (figure 45
on page 15) . Apply pressure on the book rest until it clicks and
locks into place .
Before closing the cover, make sure no cleaning materials are
inside the binder . Once you've checked, pull down the cover .
Press down on each side of the front of the case until the latch
clicks and locks into place .
Cleaning the Outside of Your Fastback® Photobook Binder
If the outside of your Fastback® starts to get dusty, clean the
cover with a damp cloth and mild detergent .
FASTBACK PHOTOBOOK BINDER MODEL 25 USER'S MANUAL, 203794