Boston Scientific Precision SC-5312 Manual Del Usuario página 4

Precision Charging System
2. Position the Charger in the Base Station
on a flat surface with the blue power
button facing up. Do not remove the
Charger until the indicator light above
the power button turns green, indicating
that the Charger is ready for charging
the Stimulator. Remove it from the Base
Station.
1. Indicator Light
2. Charger
3. Power Supply
NOTE: The Charger may not be able to
fully charge the Stimulator when the light is
amber-colored.
3. Using the Adhesive Patch:
• Apply the adhesive patch to the
backside of the Charger by peeling
the clear side with the blue line from
the patch and applying the patch to
the Charger, as shown. (See diagram
below.)
• Remove the skin side beige liner
from the adhesive (only good for one
fixation). (See diagram below.)
Precision Charging System
9055937-005 REV A Page 4 of 54
4. Power Button
5. Base Station
OR
Using the Charging Belt:
• Place the Charger into the pocket
on the Charging Belt with the power
button facing out. (See diagram
below.)
4. Press the power button. The indicator
light will come on again, and the Charger
will begin beeping steadily to signal that it
is searching for the Stimulator.
5. Locate the Charger over the Stimulator.
When the Charger is aligned with the
Stimulator, the beeping will stop.
6. Secure the Charger over the Stimulator
either by pressing the adhesive to the skin
over the Stimulator, or by securing the
Charging Belt.