Boston Scientific Precision SC-5312 Manual Del Usuario página 5

NOTE: If you accidently locate the patch
in the wrong place, or if the Charging Belt
moves out of alignment, the Charger will start
beeping again. Use a new adhesive patch or
readjust the belt to place the Charger back
into position.
7. When the Charger emits a distinct double
beep, the Stimulator is charged. Switch off
the Charger, remove the adhesive patch
or Charging Belt, and return the Charger
to the Base Station.
Do not confuse the end of a charging
signal (a distinct double beep) with the
steady, continuous misalignment signal.
NOTE:
• Depending on your program
parameters, you may expect daily
recharging times as low as 10 minutes
up to four hours, or weekly recharging
times from as low as one hour up to
four hours.
• The end of a charge signal is a distinct
double beep, and the alignment
indicator is a steady continuous
signal.
Maintenance
The parts may be cleaned with a cloth lightly
dampened with water or a mild household
cleaner. Do not use abrasive cleansers on the
components. If necessary, remove traces of
adhesive residue using an alcohol-moistened
cloth.
Customer Service - USA
In USA, to order replacement parts, or
for answers to any questions you might
have, please contact the Customer Service
Department:
• Phone: (866) 360-4747,
+1 (661) 949-4747
• Fax: +1 (661) 949-4022
Corporate Headquarters:
Boston Scientific Neuromodulation
25155 Rye Canyon Loop
Valencia, CA 91355 USA
Customer Service -
Outside USA
For Physicians, if you have any other
questions or need to contact Boston
Scientific, choose your locality from the
contact list at the end of this document
For Patients, if you have a specific question
or issue, please contact your healthcare
professional.
Limited Warranty
Boston Scientific Corporation (referred to
as Boston Scientific) warrants to the patient
that the Charger System (Charger and/or
Precision Charging System
9055937-005 REV A Page 5 of 54
Maintenance