Cisal WAVE WA00025 Información Técnica página 16

- Insert the plate (1) on the spout and fasten
it with the dowel (2) tightening with 2 mm
Allen wrench.
- Insert the hole cover plate (3).
- Remove the protection film from the spout.
- ONLY FOR ITEM WA00026 :Assemble
the knob (4) and fasten it with the dowel (5)
tightening with 2 mm Allen wrench.
- Tighten the hexagonal counter nut (1) on the
tail piece; insert the stainless washer (2) and
the gasket (3).
- Insert the tail piece in the hole of the top (red
point = hot water ; blue point = cold water).
- Insert the gasket (4) and fasten the stand
tightening the counter nut (5) with Allen
wrench 38 mm. WARNING : check that top's
overhang is between 39 and 41 mm.
- Assemble the cap (6) on the counter nut (5)
and tighten it with the dowel (7) tightening it
with 2 mm Allen wrench.
- Insert the plate (8).
- Assemble the plastic ring (9) , the hole-co-
ver plate (10) and the handle (11) fastening
everything with dowel (12) tightening it with
2 mm Allen wrench.
- Connect the supply spout to the tail pieces
tightening the nuts of the hoses (13) with 24
Allen wrench (insert the gaskets (14) betwe-
en the nuts and the connections).
16