Installation Steps - LUND 318096 Instrucciones De Instalación

Installation Steps

Starting at the driver side, locate the (3) pairs of factory holes in the pinch weld. (Fig. 1 and Fig. 2)
Fig. 1 Driver side front mounting location pictured.
1
Move toward the front pair. Remove the rubber plug filling the
oval hole in the bottom of the rocker panel in front of the two
holes. (Fig. 3)
Remove rubber plug
Fig. 3
2
Thread the retainer all the way down the Bolt Plate and tight against
the body panel. (Fig. 5) NOTE: The Plastic Retainer is designed to
prevent the Bolt Plate from falling into the body cavity and to aid in
installing the Bracket.
After inserting,
rotate Bolt Plate
90-degrees to go
across the slot
or until Bolt Plate
stops.
4
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
Mounting
holes in pinch
weld
Fig. 5
Fig. 2 Driver side rear mounting location pictured.
Select (1) 12mm Bolt Plate and (1) 12mm Plastic
Retainer. Partially thread the Retainer onto the Bolt
Plate. Insert the Bolt Plate into the hole and rotate it
90-degrees to go across the slot. (Fig. 4)
3
Select (1) Mounting Bracket and secure it to the Bolt
Plate with (1) 12mm Serrated Flange Nut. (Fig. 6) Do
5
Page 2 of 5
(1) 12mm x 40mm Bolt Plate
(1) 12mm Plastic Retainer
Fig. 4
not tighten hardware at this time.
Fig. 6
(1) 12mm Flange Nut