LUND 318096 Instrucciones De Instalación página 3

Installation Steps
Line up the (2) small slots in the Bracket with the (2) holes in the pinch weld. Insert (1) 6mm x 25mm Hex Bolt and (1) 6mm
x 18mm Flat Washer through the pinch weld and then the Bracket. Secure the bracket to the Hex Bolt with (1) 6mm x 22mm
Large Flat Washer and (1) 6mm Nylon Lock Nut over the Bracket. (Fig. 6) Do Not tighten hardware at this time. Repeat for
remaining mounting hole in Bracket and pinch weld. NOTE: Insert 6mm Hex Bolts with Flat Washers through the back of the
6mm x 25mm Hex Bolts
6mm x 18mm Flat
Washers
6
NOTE: Insert 6mm Hex Bolts with Flat Washers through the back of the pinch weld first, and then out through the Bracket.
IMPORTANT: The passenger side of the vehicle may have a wiring harness attached behind the pinch weld, (Figure 7).
Remove the hex nuts and drop the harness down before installing the Brackets, (Figure 8). 6mm Hex Bolts install from the
inside first, then through the Bracket to clear the harness. Snug but do not fully tighten hardware at this time.
Fig. 7
7
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
pinch weld first, and then out through the Bracket.
Fig. 6
Page 3 of 5
6mm x 22mm Flat Washers
6mm Nylon Lock Nuts
Fig. 8
Remove hex nuts from
wiring harness. Drop
harness down to install
Brackets.