Using The Jug & Stacked Blade Assembly; Important - Ninja CB350EU Instrucciones

USING THE JUG & STACKED BLADE ASSEMBLY
IMPORTANT: Review all warnings on
pages 52-55 before proceeding.
IMPORTANT: As a safety feature, when
the unit is powered on, if the jug and
lid are not properly installed, the timer
will display "- -" and the motor will be
disabled. If this happens, repeat step 5
on the following page. When the jug and
lid are properly installed and the unit is
powered on, the program button LEDs
will illuminate, indicating the appliance is
ready to use.
NOTE: Auto-iQ® programs have pauses and
changes in speed throughout the cycle.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: If the Stacked Blade Assembly is
not fully seated, you will not be able to
install and lock the lid.
NOTE: The jug lid handle will not fold
down unless it is attached to the jug.
1 Plug in motor base and place on a clean,
dry, smooth, level surface such as a
worktop or table.
2 Lower the Jug onto the motor base. The
handle should be aligned slightly to the
right and the jug should be oriented so
the LOCK symbols are visible on the
motor base. Rotate the jug clockwise
until it clicks into place.
60 ninjakitchen.eu
3 Exercising care, grasp the Stacked Blade
Assembly by the top of the shaft and
place it onto the drive gear inside the jug.
Note that the blade assembly
will fit loosely onto the drive gear.
4 Add ingredients to the jug. DO NOT add
ingredients past the MAX LIQUID line on
the jug.
5 Place the lid on the jug. Press down on the
handle until it clicks into place. Once the lid
is locked in place, press the Power button
to turn unit on. The available program
buttons will illuminate and the unit will be
ready for use.
6a If using an Auto-iQ® program, use the dial
to select the program that best suits your
desired output, then press START/STOP.
The preset feature will automatically stop
at the end of the program. To stop the unit
at any time, press START/STOP.
6b For Manual mode, press IQ/MANUAL.
Use the dial to select your desired
speed, ranging from 1 to 10 and press
START/STOP. Once the ingredients have
reached your desired consistency, press
START/STOP and wait for the unit to
come to a complete stop.
7 Remove the jug from the motor base
by turning it anti-clockwise and then
lifting up.
8a To pour out thinner mixtures, ensure the
lid is locked in place, then open the pour
spout cap.
8b For thicker mixtures that cannot be
emptied through the pour spout, remove
the lid and Stacked Blade Assembly before
pouring. To remove the lid, press the
RELEASE button and lift the handle. To
remove the blade assembly, carefully grasp
it by the top of the shaft and pull straight
up. The jug can then be emptied.
9 Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance section
for cleaning and storage instructions.
ninjakitchen.eu 61