Nice RC2 Instrucciones Y Advertencias Para La Instalación Y El Uso página 8

Mode I (simplified memorization)
In this mode the functions of the transmitter keys are pre-set. The keys are
associated by pairs: keys 1 and 2 can perform the On-Off commands from
an RC2 receiver, whereas keys 3 and 4 can perform the On-Off commands
from a different RC2 receiver, as shown in the example below.
When the memory is empty (no memorized transmitters) you can proceed to
program the first transmitter in Mode I as shown in table [A].
WARNING: if you press key 1 or 2, this pair of keys will be me morized,
whereas if you press key 3 or 4, this latter pair of keys will be memorized.
Table [A] Memorizing the first transmitter
in Mode I
1 Power the receiver: you will hear two long
beeps
2 Within 5 seconds, press one of the keys
in the desired pair (pair 1-2 or 3-4) on the
transmitter and hold it down
3 Release the key when you hear the first of
the 3 beeps confirming the memorization
If the receiver has already memorized one or more transmitters, when it is
switched on you will hear 3 short beeps. In this case you will not be able to
proceed as described above, but will have to switch to the memorization mode
described in Table [B]
6 – English
Example
5s