G Problems And Solutions - Fisher-Price L5198 Manual De Instrucciones

Problem
No bubbles
Bubble solution is leaking from
the mower
Bubble solution is foaming

G Problems and Solutions

Cause
Not enough bubble solution in
bubble chamber
Bubble chamber is clogged
and dirty
You have not walked far enough
to produce bubbles
You are walking too quickly
The rear wheels do not contact
the ground
Silicone or oily lubricants
may have gotten in the
bubble chamber
Bubble chamber over-fi lled
The mower is used on an
inclined surface
Bubble chamber is clogged
15
Solution
Press down on bubble solution
bottle for 15 seconds to refi ll.
Follow instructions in "Let's
Clean Up" section to clean bubble
chamber thoroughly.
The bubble mower needs to be
pushed a minimum of 15-20
walking steps before bubbles
begin to fl ow.
Walk at a slow, steady pace.
Push the mower so that the
rear wheels always contact
the ground.
Never use silicone or oily
lubricants on this product (the
wheels). Bubbles will not form
if even a very small amount of
these substances get into the
bubble chamber.
Fill only by using fi ller cap. The
fi ller cap dispenses the correct
amount of solution.
Use the mower only on fl at,
level ground.
Follow instructions in "Let's Clean
Up" section to clean bubble cham-
ber thoroughly.