Metra 95-6522B Instrucciones De Instalación página 3

7. The dash cavity will need to be cut
to make room for the aftermarket
equipment. Cut and remove the
shelf below the factory radio.
Don't cut away the factory radio
mounting positions.
8. Locate the spots where the two
dash parts are welded together.
Slide a flat head screw driver
between the two plastic panels
and rotate the screwdriver so
that it forces the two plates apart.
(Figure C and D)
Note: If desired, the welds can
be pre-drilled softly with a 1/4"
drill bit to help the welds apart.
Continue to kit assembly
Dash Disassembly
(Figure C)
95-6522B
(Figure D)
3
Rear view with
panel removed.