DAYTEK MK 2 Manual De Instrucciones página 11

To attach a new line
1. Start by clamping one end of the new line into
ARM 1 as shown below (ARM 1 can be any arm
you choose).
2. Work your way around the clothesline
attaching the line at ARM 2, 3 & 4 as shown
below. Ensure line is pulled tight and clamped
in Tensioner Block before moving on to
next arm.
ARM 1
STRING ONE END
ARM 2, 3 & 4
STRING LINE
HOW TO TENSION THE LINE ON YOUR DAYTEK ROTARY CLOTHESLINE
1. At the required tensioning point, place your index
finger on top of the Tensioner Block Top and over
the Nut to ensure that the Nut is held in position.
2. Loosen the bolt from under the arm of the
clothesline.
STRING BOTH ENDS
TERMINAL BLOCK TOP AFFIXED
3. When you arrive back at ARM 1, remove the
Tensioner Block Top and clamp both line ends
into line tensioner as shown below, making
sure the lines are pulled tight.
4. Trim line ends leaving approximately 5cm
(2 inches).
TERMINAL BLOCK TOP AFFIXED
3. Pull the line through the Tensioner Block to
required tension and re-tighten the bolt.
4. Repeat this process around the clothesline
working the slack cord towards the end of
the line.
11