Getting Started - auna KR-140 Manual De Instrucciones

EN
28

GETTING STARTED

Afer connecting to power the appliance starts an initialisation. When the
device is in the initializing stage, then you will see the LED segments to
display as animation below show.
This stage should keeping for about 2 ~ 3 minutes to complete;
Then the clock time will be showed on LED segment display for view. (CT
sync and automatically adjusted).
• The clock time may not be adjusted if those background received FM
station(s) have no RDS's CT signal provided or RDS signal's strength is
too low. (In this case the clock should show "00:00")
• Then manual clock time adjustment is requires in this case. (see below
adjustment steps.
• Manual clock set adjustment methods
• Short press the " /ST (5)" button to entry time format set;
• The LED display will show blinking "24H" or "12H" for 6 seconds;
(factory defaulted is "24H")
• Rotates the "Adjustment (16)" button to " -" or " +" for selects the desired
time format.
• Short press the "Adjustment (16)" button to confirm the time format set
and go for hour set, the number of hour will blinking;
• Rotates again the "Adjustment (16)" button to " -" or " +" for selects the
hour time as current time;
• Short press again the"Adjustment (16)"button to confirm the hour time
set and go for Minute set. The number of minute will blinking;
• Rotates again the "Adjustment (16)" button to "- " or " +" for selects
the minute time as current time and short press the "Adjustment (16)"