Kohler K-328 Guia De Instalacion página 4

1/2" (1.3 cm)
1/2" x 3/4" Flush
Bushing (Supplied)
1/2" or 3/4" Piping
2. Install the Spout
When installing a spout with a diverter:
Remove the temporary nipple.
If 3/4" piping is used, install a 3/4" nipple to extend 1/2" (1.3
cm) beyond the finished wall.
If 1/2" piping is used, the supplied 3/4" to 1/2" reduction
bushing should be installed now. Install a 1/2" nipple extending
1/2" (1.3 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant to the back of
the spout flange according to the manufacturer's instructions.
Slide the spout flange onto the spout.
Apply thread sealant to the nipple, and install the spout to the
nipple.
Carefully tighten with a clean strap wrench.
When installing a non-diverter spout:
Remove the temporary nipple.
Install a 1/2" nipple extending 6-1/4" (15.9 cm) beyond the
finished wall.
Apply a bead of plumbers putty or other sealant to the back of
the spout flange according to the manufacturer's instructions.
Slide the spout flange onto the spout.
112562-2-BB
6-1/4" (15.9 cm)
1/2" Piping
4 Kohler Co.