Record Table; Instructions For Use; Start-Up - Terragene Bionova MiniBio Manual De Usuario

Record Table

Use the following table to record firmware updates.
NOTE: manufacture firmware is printed on a label found
on the bottom of the incubator and on its packaging.
Please, register your manufactory firmware in this manual
for future reference:
Manufacture Firmware:
Fecha Versión

Instructions for use

Start-up

If you want to change the time zone, refer to Modification
of time zone section. If you want to change the print lan-
guage, refer to Modification of print language section.
1-Place the auto-reader on a firm surface, free from vibra-
tions, away from sunlight, currents of hot or cold air, che-
Operador
mical and corrosive or flammable substances. Do not pla-
ce the equipment in a way that disconnection of the plug
from the power supply could be difficult. Leave a gap of
at least 10 cm from the wall. Do not move the auto-reader
periodically or during its use. Connect the auto-reader to
a secure and stable electrical power source.
2-Turn on the incubator by connecting the end of the AC
of the power supply to the power source and then con-
nect the other end of the source (plug) on the rear of the
Bionova® MiniBio unit. The equipment will start by run-
ning the last time and temperature set-up.
3-Synchronize the Bionova® MiniBio incubator with lo-
cal time, using Bionova® software available in:
www.terragene.com.ar/products/infection-control/
control-of-sterilization-processes/incubators/minibio/.
Connect incubator USB port to the computer and start
the program. Bionova® MiniBio incubator unit will be
synchronized with computer time. This synchronization
can only be used when the reading positions are empty.
4- Check that required incubation temperature is correct.
To change it, press button
ponding to 37 ºC and 60 ºC will start blinking, indicating
that the temperature program must be selected. Press
the
gram, 37 ºC or 60 ºC. After 3 seconds, temperature modifi-
cation will be accepted.
For 37 ºC, Bionova® MiniBio auto-reader will automatically
select 4 hs. final readout for all positions.
For 60 ºC the incubator allows choosing between 30 mi-
nutes, 1 hour, 2 hours or 3 hours final readout. It is possi-
Bionova® MiniBio Page 6
All devices are manufactured with the following
settings:
- Time zone: UTC +0:00
- Printing language: English
Do not wet or heat the auto-reader. If liquid is spi-
lled on the incubator, disconnect it and dry it im-
mediately. Before turning on, verify that all reading
positions of the MiniBio incubator are empty.
3 seconds. Lights corres-
button to select the incubation temperature pro-
http://