Suaoki Wireless Cadence Manual Del Usuario página 15

* 2 Wheel Circumference
You can find the wheel circumference (L) of your bike in the Appendix.
Usually, ETRTO or tire size is indicated on the side of the tire. You could
also measure tire circumference by doing a wheel roll out:
[Refer to Diagram 8]
With the tires under proper pressure, place the valve stem at the
bottom. Mark the spot on the floor and with the rider's weight on the
bike, roll exactly one wheel revolution in a straight line (until the valve
comes around again to the button). Mark where the valve stem is and
measure the distance between the two markers.
*3 Total Distance & Total Ride Time
Data would be deleted once you replace this device's battery. In this
case, you could enter the total distance and time manually, so you
don't have to start from nothing.
Pairing
[Refer to Diagram 2]
Pair the computer unit with the sensor
Step 1: When you are done with setting, the bike computer will enter
the pairing mode automatically. At this stage, you need to install
battery to the sensor. When using the sensor for the first time, make
sure to remove the insulation pad from the sensor.
Step 2: Place the bike computer and the sensor together. The distance
between computer unit and sensor should not exceed 3m.
Step 3: When the pairing is successful, the LCD screen would display
"PAIR OK" and then speed would display on screen. When the pairing
is not successful, the speed display would be "--". [as shown in
Diagram 2]
Note:
Remember to pair the computer unit with the sensor every time
when you replace the computer unit or the sensor with a new battery.
EN-13