Suaoki Wireless Cadence Manual Del Usuario página 16

Install the device on bike
Install the bracket and computer unit
Step 1: Attach the rubber slice on handlebar/stem.
Step 2: Stick the bracket on the handlebar/stem.
Step 3: Hang the O-ring on one side of the bracket. Go around the
handle bar or stem. After that, secure the O-ring to the other side of the
bracket. For more stability, you could fix the bracket using cable ties.
Now, the bracket should be properly installed. [refer to instructional
video]
Step 4: Set the computer into the notch of the bracket (NW/SE
direction), push on gently and clockwise to fix the computer unit.
Note:
You can loosen the four screws on the bracket to change its
orientation.
Install the sensor and magnets
[Refer to Diagram 6]
Step 1: Install Speed Magnet
Installed the speed magnet on the bicycle spoke. Secure the magnet
and tighten the screw.
Step 2: Install Cadence Magnet.
Attach the cadence magnet to the bike crank arm with straps.
Step 3: Install Speed and Cadence Sensor
Attach the speed and cadence sensor to the bike chainstay with cable
ties. When installing speed sensor, the side marked with 'sensor' need
to face towards the wheel direction and stay close to the speed
magnet. When installing the cadence sensor, you need to make sure
the cadence sensor face towards and stay close to the the cadence
magnet.
Step 4: Adjust the position of computer unit, sensor and magnets.
Tighten the cable ties and cut off the excessive part of the ties.
EN-14