Volvo Penta 3861803 Instrucciones De Montaje página 6

6
TRIM SENDER INS TRIM SENDER INS TRIM SENDER INST T T T T ALL TRIM SENDER INS TRIM SENDER INS ALL ALL ALLA A A A A TION ALL
Apply Volvo Penta Grease to the trim/tilt sender lead
grommet. Feed the wires through the opening in the
rear of the gimbal housing, and out through the
transom plate. Push the grommet into the hole until it
seats.
Note! Do not route trim/tilt sender leads under
extension tube or hydraulic lines. Leads must
be free to move when drive unit steers, other-
wise sender or wire will be damaged.
Attach the retaining clip to the grommet inside the
transom plate.
Install the RIBBED BLACK wire in the "A" terminal, the
RED wire in the "B" terminal and SMOOTH BLACK
wire in the "C" terminal on the Amphenal connector.
Use Socket Installer, Volvo Penta P/N 3854349-2, to
push the wire sockets into the rubber plug until they
seat.
Note! The use of alcohol will make socket
installation into the rubber plug easier.
TRIM SENDER ADJUSTMENT TRIM SENDER ADJUSTMENT TRIM SENDER ADJUSTMENT TRIM SENDER ADJUSTMENT TRIM SENDER ADJUSTMENT
With sterndrive trimmed to the down or in limit, insert
sending unit control nut into pivot bolt head
TION TION TION TION
A .