Removing Or Installing Hedge Shear Blades; Removing The Hedge Shear Blades - Makita HU01 Manual De Instrucciones

Cortasetos inalámbrico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing or installing hedge shear blades

CAUTION:
Before removing or installing shear blades, always
be sure that the tool is switched off and the battery
cartridge is removed.
When replacing the shear blades, always wear
gloves without removing blade cover so that hands
and face do not directly contact the blade. Failure
to do so may cause personal injury.
NOTE:
Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
For specific way of removing and installing shear
blades refer to the reverse of a package for
accessory shear blades.

Removing the hedge shear blades

1
010890
CAUTION:
Install the blade cover before removing or
installing the shear blades.
Reverse the tool.
1
4
010891
To remove the shear blades, press the locking lever and
with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
1. Blade cover
1. Undercover
2
2. Locking lever
3. Press
3
4. Turn
on the undercover
on the locking lever.
1
010892
Take out the undercover from the tool.
010893
Loosen two screws with a coin and similars and remove
the shear blades.
NOTE:
Do not remove the screws. Without removing the
screws loosened, shear blades can be removed.
1
010894
Remove the crank from the shear blades.
NOTE:
The crank may remain in the tool.
11
1. Undercover
1. Screws
1
1. Crank
2. Shear blades
2

Publicidad

Tabla de contenido
loading

Tabla de contenido