Makita HU01 Manual De Instrucciones página 9

OPERATION
Refer to the Safety Warnings before operation.
CAUTION:
Be careful not to accidentally contact a metal
•
fence or other hard objects while trimming. The
blade will break and may cause serious injury.
Also, be careful for the shear blade not to contact
•
the ground.
Overreaching with a hedge trimmer, particularly
•
from a ladder, is extremely dangerous. Do not
work from anything wobbly or infirm.
010878
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
CAUTION:
Do not cut off dead trees or similar hard objects.
•
Failure to do so may damage the tool.
Do not trim the grass or weeds while using hedge
•
shear blade. The shear blade may entangle the
grass or weeds.
010879
Hold the trimmer with one hand, depress the lock-off
button and pull the switch trigger and then move it in
front of your body.
1
3
010880
As a basic operation, tilt the blades towards the
trimming direction and move it calmly and slowly at the
speed rate of 3 - 4 seconds per meter.
010881
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
010966
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
010967
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
9
1. Trimming
direction
2. Tilt the blades
3. Hedge surface
to be trimmed
2
1. String
1