6) Using washer line (G) and barb splices (B) provided in the kit, connect washer lines and route to the Heater Manifold.
Flow direction through Heater Manifold is not important.
7) Firmly press the washer lines onto the fittings at each
end of the Heater Manifold (A).
8) Secure the windshield washer fluid hoses using small
cable tie straps (E). Make certain that there are no kinks
or sharp bends in the washer fluid lines. Be sure cable
ties are loose enough not to pinch or deform the shape
of the hose. Restricting the washer fluid line will cause
a delay in washer fluid system response.
Recommended spacing for cable ties is no more
than 150mm apart.
5/9/14
4 of 5