DOCOL 00503806 Manual De Instrucciones página 12

Maintenance
SYMPTOMS
The drive is not made when the
sensor is activated.
The flush valve produces audible
"click".
Water supply failure
The gate valve is closed
The drive is not made
when the sensor is activated.
The flush valve don't produces
audible click.
Unavailability of power for the sensor.
Switch mode power supply not
connected to the power.
Switch mode power supply not
connected to the sensor.
Sensor cable is damaged.
Solenoid is damaged.
Solenoid undocked.
Plunger locked.
Lack of lubrication at the plunger.
Acionamento contínuo da válvula.
Sensor com problema.
Piloto travado.
Baixa vazão.
Parafuso de ajustagem da válvula
desregulado.
Solenóide desencaixado.
Tempo de acionamento programado
no sensor insuficiente para atingir o
fluxo do vaso sanitário.
Persisting problem, contact the Docol Authorized Distributor in your country.
12
ENGLISH
SOLUTIONS
Open water supply stop valve.
Open internal flow control.
Check and reset the breaker.
Connect the power cord from the switch mode
power supply at the electricity point.
Connect the supply cord to the sensor cable.
Contact the Docol Authorized Distributor in your
country.
Contact the Docol Authorized Distributor in your
country.
Reassemble the solenoid on the frame.
Reassemble the plunger on the solenoid.
Lubricate the inside of the plunger with grease.
Contact the Docol Authorized Distributor in your
country.
Reassemble the plunger on the solenoid.
Adjust the screw as shown
in the installation guide.
Reassemble the solenoid on the frame.
Contact the Docol Authorized Distributor in your
country.
PAGE / PICTURE
8/ 1
7 / 3
10 / 9
9 / 6
9 / 7
9 / 7
7 / 3
9 / 6