Ebode RMA Guia Del Usuario página 6

Receiver - Wall-Mounted Appliance Module
Pls bear in mind to shut off general mains in the
electrical panel.
To connect the in-wall switch
How to connect Live + Neutral Input
L : stands for input Live 230V - 50 Hz
N : stands for input Neutral 230V - 50Hz
Wiring up Live +
Neutral outputs
How to instal wall mount switch
Wall insert box : dia. 65mm, 40mm deep
1.Gently take off paddle from wall switch.
2.Wire up Wall Switch within wall insert box, then
fix receiver along with provided screws against wall
insert box.
Please note that the general mains in the electrical panel
should be turned on again before you start programming.
To learn one address on wall switch (unique
addressable control)
An address is made of a HOUSE code and UNIT code, please refer
to the manual of the transmitter to properly fix the code to learn
by the receiver.
The following procedure consists of learning one (or even more
than one) address from the transmitter into the RMA receiver.
July 2009
N : Neutral
C : (do not connect, only
for low voltage)
: Output Live appliance or light to control
CONNECTING BLOCK
Connect all wires as indicated (refer to
wiring diagram 1)
Ph
N
page 6
.
Up to 10 Amps
Schematic 1
.
Ref : RMA
RMA