Publicidad
SLIDING CLASP BRACELET
Open locking plate. Move clasp to desired bracelet
length. Exert pressure while holding locking plate and
slide clasp back and forth until it engages in grooves
on underside of bracelet. Press locking plate down
until it snaps closed. Clasp can be damaged if exces-
sive force is used.
FOLDOVER CLASP BRACELET
Find spring bar that connects bracelet to clasp. Using a pointed tool
(Fig. 1), push spring bar in and gently twist bracelet to disengage.
Determine wrist size, then insert spring bar in correct bottom hole
(Fig. 2). Push down on spring bar, align with top hole and release to lock
in place (Fig. 3).
Fig. 1
BRACELET LINK REMOVAL
Removing Links: Place bracelet upright
and insert pointed tool in opening of link.
Push pin forcefully in direction of arrow
until link is detached (pins are designed to
be difficult to remove). Repeat until desired
number of links are removed.
Reassembly: Rejoin bracelet parts. Push pin back into link in opposite
direction of arrow. Press pin down securely into bracelet until it is flush.
SOLID LINK BRACELET
Removing Links: Using a very small screw-
driver, remove screws by turning counter-
clockwise. Repeat until desired number of
links are removed. Do not remove links adja-
cent to clasp.
Reassembly: Rejoin bracelet parts and
insert screw in end of opening where it was
removed. Turn screw clockwise until tight and flush with bracelet.
WARNING: TO MAINTAIN WATER RESISTANCE ON ANY WATCH,
THE CROWN SHOULD NOT BE PULLED OUT WHEN THE WATCH IS
SUBMERGED IN WATER. ADDITIONALLY, PUSHERS ON WATCHES
WITH A WATER-RESISTANCE DEPTH RATING OF LESS THAN 200
METERS, SHOULD NOT BE PUSHED WHEN SUBMERGED IN WATER.
EITHER OF THESE ACTIONS COULD RESULT IN WATER ENTERING THE
WATCH CASE.
1. Watch is water-resistant only as long as crystal, crown and case
remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Screw-in setting crown and case back must be screwed into case to
assure water-resistance (see Set Time). (Optional)
4. Rinse watch with fresh water after exposure to salt water.
5. Shock-resistance will be indicated on watch face or caseback.
Watches are designed to pass ISO test for shock-resistance. However
avoid damaging crystal/lens.
If your watch is water-resistant, meter marking or (O) is indicated.
Water-Resistance Depth
30m/98ft
50m/164ft
100m/328ft
200m/656ft
*pounds per square inch absolute
Timex strongly recommends that a retailer or jeweler replace
battery. If applicable, push reset button when replacing battery. Battery
type is indicated on caseback. Battery life estimates are based on
certain assumptions regarding usage; battery life may vary depending
on actual usage.
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP
LOOSE BATTERIES AWAY FROM CHILDREN.
(U.S. – LIMITED WARRANTY – PLEASE SEE FRONT OF INSTRUCTION BOOKLET
Your TIMEX
®
watch is warranted against manufacturing defects by Timex Group USA, Inc. for a period
of ONE YEAR from the original purchase date. Timex and its worldwide affiliates will honor this
International Warranty.
Please note that Timex may, at its option, repair your watch by installing new or thoroughly
reconditioned and inspected components or replace it with an identical or similar model.
IMPORTANT — PLEASE NOTE THAT THIS WARRANTY DOES NOT COVER DEFECTS OR DAM-
AGES TO YOUR WATCH:
1) after the warranty period expires;
2) if the watch was not originally purchased from an authorized Timex retailer;
3) from repair services not performed by Timex;
4) from accidents, tampering or abuse; and
5) lens or crystal, strap or band, watch case, attachments or battery. Timex may charge you for
replacing any of these parts.
THIS WARRANTY AND THE REMEDIES CONTAINED HEREIN ARE EXCLUSIVE AND IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR PARTICULAR PURPOSE. TIMEX IS NOT LIABLE FOR ANY SPECIAL, INCIDENTAL OR CON-
SEQUENTIAL DAMAGES. Some countries and states do not allow limitations on implied warranties
and do not allow exclusions or limitations on damages, so these limitations may not apply to you.
This warranty gives you specific legal rights and you may also have other rights which vary from
country to country and state to state.
To obtain warranty service, please return your watch to Timex, one of its affiliates or the Timex retail-
er where the watch was purchased, together with a completed original Watch Repair Coupon or, in
the U.S. and Canada only, the completed original Watch Repair Coupon or a written statement iden-
tifying your name, address, telephone number and date and place of purchase. Please include the
following with your watch to cover postage and handling (this is not a repair charge): a US$ 8.00
check or money order in the U.S.; a CAN$7.00 cheque or money order in Canada; and a UK£2.50
cheque or money order in the U.K. In other countries, Timex will charge you for postage and han-
dling. NEVER INCLUDE A SPECIAL WATCHBAND OR ANY OTHER ARTICLE OF PERSONAL VALUE IN
YOUR SHIPMENT.
For the U.S., please call 1-800-448-4639 for additional warranty information. For Canada, call 1-800-
263-0981. For Brazil, call +55 (11) 5572 9733. For Mexico, call 01-800-01-060-00. For Central America,
the Caribbean, Bermuda and the Bahamas, call (501) 370-5775 (U.S.). For Asia, call 852-2815-0091.
For the U.K., call 44 020 8687 9620. For Portugal, call 351 212 946 017. For France, call 33 3 81 63
42 00. For Germany/Austria, call +43 662 889 2130. For the Middle East and Africa, call 971-4-
310850. For other areas, please contact your local Timex retailer or Timex distributor for warranty
information. In Canada, the U.S. and in certain other locations, participating Timex retailers can pro-
vide you with a postage-paid, pre-addressed Watch Repair Mailer for your convenience in obtaining
factory service.
©2010 Timex Group USA, Inc. TIMEX and QUICKDATE are registered trademarks of Timex Group USA,
Inc. INDIGLO is a registered trademark of Indiglo Corporation in the US. and other countries.
BRACELET ADJUSTMENT
WATER AND SHOCK RESISTANCE
TIMEX INTERNATIONAL WARRANTY
FOR TERMS OF EXTENDED WARRANTY OFFER)
Fig. 2
p.s.i.a.* Water Pressure Below Surface
BATTERY
Fig. 3
60
86
160
284
Publicidad
