Parameter Setting - aquatermic XK49 Manual Del Usuario

Wired Controller XK49
View the air
outlet
C20 temperature of
Fresh Air
Indoor Unit*
Note:
① Under parameter viewing status, FAN buttons are invalid. Press "ON/OFF"
button to go back to the home page, while not to turn on/off the unit.
② Under parameter viewing status, the signal from remote controller is invalid.

3.2.3 Parameter Setting

Unit parameters can be set in unit On or Off status.
(1) Long press MODE and SWING button for 5s and the temperature zone
displays "C00"; long press MODE and SWING button for another 5s to enter
the interface of setting wired controller parameters. "P00" is displayed in
temperature zone;
(2) Press "
enter parameter setting. At that time, parameter value is blinking. Press
" " or "
to finish setting.
(3) Press SWING button to return to last step until exists setting parameters.
-
" or " " button to select parameter code. Press MODE button to
" button to adjust the parameter value and press SWING button
Operation method:
Enter viewing, short-press "MODE" button in "C20"
status to enter the interface of viewing air outlet
temperature of Fresh Air Indoor Unit. Press "
" " button to select the indoor unit.
Display method:
Temperature zone: displays current indoor unit project
number
Timer zone: displays air outlet temperature of Fresh
Air Indoor Unit
Note: only applicable to Fresh Air Indoor Unit.
24
" or