aquatermic XK49 Manual Del Usuario página 28

The parameter setting list is as following:
Parameter Parameter
code name
Set master
P10
indoor unit
Set infrared
P11 receiver of wired
controller
Set address of
P13
wired controller
Set quantity of
P14 group control
indoor units
Set unit of
P16
temperature
Table 3.2 Parameter setting list
Parameter Default
range value
00: do not
change
current
master/slave
state of indoor
unit
01: set current
indoor unit as
master indoor
unit
00: forbidden
01: activated
01: master
wired controller
02: slave wired
controller
00: forbid this
function
01-16: indoor
unit quantity
00:Celsius
01:Fahrenheit
25
Wired Controller XK49
When set the correspond-
ing indoor unit of wired controller as
master indoor unit, MASTER" icon will
00
be bright after finishing sett-
ing.
It can be set only through master
wired controller.
When infrared receiver of wired
01 controller is forbidden, the wired
controller can't receive the signal from
remote controller and it is operated
through buttons.
When two wired controll-
ers control one indoor unit (or several
indoor units), the addresses of the two
01 wired controllers should be different.
Assistant wired controller (02) is
without unit parameter setting function
except setting its address.
Set the corresponding value
01 according to the connected indoor unit
quantity.
00
Note