Description Of The Appliance; Putting Into Operation - Boneco W2055A Manual De Instrucciones

Description of the appliance

Cover
Control panel
Upper part
Air outlet
1 disk pack with
16 humidifying discs
Rotary lock
Fragrance container
and rotary lock opener
for humidifying disks
Water base
Adjusting the cable length
The overall length of the cable is approx. 2 m,
but this can be adjusted as required.
• Switch the appliance off and remove the
power plug from the mains socket. Do not
pull on the cable (16).
• Open the cover (17 and 18)
1. Insert the screwdriver
(into the hole provided)
2. Press outwards
3. Push upwards
• Pull the cable from the cable
compartment (19)
• Adjust the cable length by pulling/pushing
• Store the remaining cable in the cable
compartment
• Close the cover (20)
Water tank
Water tank cap
®
Ionic Silver Stick (ISS)

Putting into operation

The best location for your appliance is:
• On the floor, or on a level, dry surface in the room.
• Pay proper attention to easy accessibility and sufficient
space for servicing and cleaning the unit.
• For increased evaporation performance in large rooms,
place the appliance near a radiator (warning: a tempe-
rature of 50 °C must not be exceeded).
• Read the section «Filling the tank» on how to fill the
water tank (21 – 24).
• Place the water tank on the lower part (25).
• Connect the mains cable to the mains and switch the
appliance on using the On/Off switch.
• The unit will reach full capacity about 10 – 15 minutes
after you switch it on.
• Ensure that the mains cable is not trapped (9). Do not
switch on the unit if the mains cable is defective (2).
en
19