Dash Disassembly - Metra 99-8721B Instrucciones De Instalación

1. Unclip and remove cover around
shift lever and cup holder.
(Figure A)
2. Unclip and remove ashtray
assembly. (Figure B)
3. Remove (2) Torx screws from the
bottom of the climate control unit
then remove the unit. (Figure C)

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
99-8721B
4. Inside each vent, using a small
flat screwdriver push the lower
tab inward toward the center of
the vent and then rotate each vent
up to expose (1) Torx head screw.
Loosen the Torx screws (It is not
(Figure D)
2
necessary to remove the screws.) Push
the upper clip inward and rotate the
vent downward to expose (1) spring
clip in the top of the vent assembly.
(Figure D)
Continued on next page