Kit Assembly - Metra 99-8721B Instrucciones De Instalación

Dash Disassembly
5. Unclip and remove the vent
assembly. (Figure E)
6. Unclip and remove the push button
panel above the radio (Figure F)
7. Remove (4) Torx screws securing
factory radio then remove the unit.
(Figure G)
8. Remove the two metal clips on the
bottom of the factory radio and
place them on the bottom tabs of
the radio housing trim panel.
Continue to kit assembly
(Figure E)
(Figure F)
(Figure G)
99-8721B
ISO DIN radio provision with pocket
1. Mount the pocket to the radio
brackets with the (4) #8 x 3/8"
Phillips screws supplied. (Figure A)
2. Mount the bracket/pocket assembly
to the radio housing trim panel with
the included #8 screws. (Figure B)
3. Slide the radio into radio brackets
and secure with screws supplied
with the unit. (Figure C)
4. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
5. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly.
3

Kit Assembly

(Figure A)
(Figure B)
(Figure C)