Additional Information; Troubleshooting - Sony TA-VE700 Manual De Instrucciones

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the amplifier, use this troubleshooting guide to
help you remedy the problem. Should any problem
persist, consult your nearest Sony dealer.
There's no sound or only a very low-level sound is heard.
/ Check that the speakers and components are
connected securely.
/ Make sure you select the correct component
on the amplifier.
/ Make sure you set the SPEAKERS selector
correctly.
/ Press MUTING on the remote if MUTING is
shown in the display.
/ The protective device on the amplifier has
been activated because of a short circuit.
("PROTECTOR" flashes.) Turn off the
amplifier, eliminate the short-circuit problem
and turn on the power again.
The left and right sounds are unbalanced or reversed.
/ Check that the speakers and components are
connected correctly and securely.
/ Adjust the BALANCE control.
Severe hum or noise is heard.
/ Check that the speakers and components are
connected securely.
/ Check that the connecting cords are away
from a transformer or motor, and at least 3
meters away from a TV set or fluorescent
light.
/ Place your TV away from the audio
components.
/ The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with alcohol.
No sound is heard from the centre speaker.
/ Select a PRO LOGIC or MOVIE (except Mono
movie) sound field (see page 11).
/ Select the appropriate centre mode
(see page 13).
/ Adjust the speaker volume appropriately
(see page 14).
Recording cannot be made.
/ Check that the components are connected
correctly.
/ Select the source component with the
function buttons.
Additional Information
No sound or only a very low-level sound is heard from
the rear speakers.
/ Turn on the sound field function.
/ Select the appropriate centre mode
(see page 13).
/ Adjust the speaker volume appropriately
(see page 14).
/ Make sure you turned on the sound field
function.
Surround effect cannot be obtained.
/ Turn on the sound field function.
/ Make sure that the SPEAKERS selector is set
to A+B when you use two sets of front
speakers.
No picture or an unclear picture is seen on the TV screen.
/ Select the appropriate function on the
amplifier.
/ Set your TV to the appropriate input mode
(press TV/VIDEO on the remote for Sony
TVs).
/ Place your TV away from the audio
components.
The remote does not function.
/ Point the remote at the remote sensor g on
the amplifier.
/ Remove the obstacles in the path of the
remote and the amplifier.
/ Replace both batteries in the remote with new
ones if they are weak.
/ Make sure you select the correct function on
the remote.
/ Pressing TV CONTROL ON sets the remote
to operate the TV only. In this case, press one
of the SYSTEM CONTROL/FUNCTION
buttons before operating the amplifier (etc.).
17 EN