Troubleshooting; Product Maintenance - HAMPTON BAY 253-425 Manual De Instrucciones

TROUBLESHOOTING:

Light will not turn on.
Fuse blows or circuit
breaker trips when light is
turned on.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off
the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the
interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a 3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a
dry soft cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of two (3) years from date of purchase. This warranty applies only to the
original consumer purchaser and only to products used in normal use and service. If this product is
found to be defective, the manufacturer's only obligation, and your exclusive remedy, is the repair
or replacement of of the product at the manufacturer's discretion, provided that the product has not
been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.
This warranty shall not apply to any product that is found to have been improperly installed, set-up,
or used in any way not in accordance with the instructions supplied with the product. This warranty
shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to faulty material or workmanship.
This warranty shall not apply to the finish on any portion of the product, such as surface and/or
weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specially disclaims any warranty, whether expressed or implied, of fitness for a particular
purpose, other than the warranty contained herein. The manufacturer specifically disclaims
any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair
of said product.
Possible Cause
1. Power is off.
2. Faulty switch.
3. Faulty wire connection.
1. Crossed wires or power wire is
grounding out.
Page 8
Corrective Action
1. Make sure power supply is on.
2. Test or replace switch.
3. Check wiring.
1. Check wire connections.