Troubleshooting; Product Maintenance - HAMPTON BAY 582-217 Manual De Instrucciones

TROUBLESHOOTING:

SYMPTOM
The light does
not turn on.

PRODUCT MAINTENANCE:

• Disconnect fixture's plug from wall receptacle.
•
To clean the fixture, use a dry or slightly dampened clean cloth (use clean water,
never a solvent) to wipe the glass and surface of the fixture
•
Do not use any cleaners with chemicals, solvents or harsh abrasives. If necessary,
use a mild soap to clean off any dirt or stains.
PRODUCT MAINTENANCE:
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of one (1) year from date of purchase. This warranty applies
only to the original consumer purchaser and only to products used in normal use and
service. If this product is found to be defective, the manufacturer's only obligation, and
your exclusive remedy, is the repair or replacement of the product at the
manufacturer's discretion, provided that the product has not been damaged through
misuse, abuse, accident, modifications, alterations, neglect or mishandling.
warranty shall not apply to any product that is found to have been improperly installed,
set-up, or used in any way not in accordance with the instructions supplied with the
product. This warranty shall not apply to a failure of the product as a result of an
accident, misuse, abuse, negligence, alteration, or faulty installation, or any other
failure not relating to faulty material or workmanship. This warranty shall not apply to
the finish on any portion of the product, such as surface and/or weathering, as this is
considered normal wear and tear.
specially disclaims any warranty, whether expressed or implied, of fitness for a
particular purpose, other than the warranty contained herein. The manufacturer
specifically disclaims any liability and shall not be liable for any consequential
or incidental loss or damage, including but not limited to any labor/expense
costs involved in the replacement or repair of said product.
POSSIBLE CAUSE
Wall switch or circuit breaker is off.
Light bulb may be dead. Test light
bulb in known working fixture.
Light bulb is loose.
Turn on the switch or circuit
breaker.
Replace the light bulb.
Tighten the light bulb in the
socket.
The manufacturer does not warrant and
SOLUTION
This