Troubleshooting; Product Maintenance - HAMPTON BAY 542-353 Manual De Instrucciones

TROUBLESHOOTING:

Bulb will not light.
Fuse blows or circuit
breaker trips when
light is turned on.

PRODUCT MAINTENANCE:

1. To clean simply wipe with a soft dry cloth.
2. Do not use any cleaners with chemicals, solvents or harsh abrasives.
The manufacturer warrants this wall sconce fixture to be free from defects in materials and workmanship for a
period of one (1) year from date of purchase. This warranty applies only to the original consumer purchaser and
only to products used in normal use and service. If this product is found to be defective, the manufacturer's only
obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion,
provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect
or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, setup,
or used in any way not in accordance with the instruction supplied with the product. This warranty shall not apply
to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or
any other failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any
portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The
manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness
for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims
any liability and shall not be liable for any consequential or incidental loss or damage, including but not
limited to any labor / expense costs involved in the replacement or repair of said product.
Possible Cause
1. Bulb is burned out.
2. Power is off.
3. Cord not plugged in.
4. Circuit breaker off.
1. Exposed wire
LIMITED WARRANTY
Corrective Action
1. Replace light bulb.
2. Make sure power
supply is on.
3. Make sure cord is
plugged into the outlet.
4. Make sure circuit
breaker is to the 'on'
position.
1. Discontinue use.
Unplug unit from the wall
and contact a qualified
electrician or call the
Home Depot Customer
Service Team at 1-877-
385 2907. -
Page 5