Checking For Wear On The Tool Shank; Fitting And Removing The Insertion Tool; Operation - Chicago Pneumatic CP 0112 Instrucciones De Seguridad Y De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 58
CP 0112, CP 0112 S, CP 0112 EX
WARNING
Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is
well-maintained, not worn out and of the proper
size.
Always use a sharp tool in order to work
efficiently.

Checking for wear on the tool shank

A
Use the gauge that corresponds to the insertion
tool s shank dimension. See section "Technical data"
for correct tool shank dimensions.
>
Check if the gauge s hole (A) can be pushed down
on the insertion tool s shank, this means that the
shank is worn out and the insertion tool should
be replaced.
>
Check the length (B), that it is according to the
ordered machine type.

Fitting and removing the insertion tool

Whenever fitting or removing the insertion tool the
following instructions must be observed:
9800 0798 90e | Original instructions
1. To prevent an accidental start: switch off the
2. Before inserting a tool, lubricate the tool shank
3. Fit or remove the insertion tool.
4. Close the tool retainer (position A) and check

Operation

Involuntary start of the machine may cause injury.
B
Safety and operating instructions
power supply and bleed the machine by
pressing the start and stop device. Disconnect
the machine from the power source.
with grease.
the lock function by tugging the inserted tool
sharply outwards.
A
WARNING
Involuntary start
Keep your hands away from the start and stop
device until you are ready to start the machine.
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
power supply interruption.
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Cp 0112 sCp 0112 ex

Tabla de contenido