WARNING: Operate only with a stopped motor.
To return back to normal mowing, remove the mulching wedge and the side discharge accessory and store
them for later usage.
7. OPERATING INSTRUCTIONS
7.1 BEFORE STARTING
Service the engine with gasoline and oil as instructed in the separate engine manual packed in your mower.
Read instructions carefully.
WARNING! Petrol is highly flammable.
Store fuel in containers specifically designed for this purpose.
Refuel outdoors only, before starting the engine and do not smoke while refueling or handling fuel.
Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot.
If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and
avoid creating any source of ignition until petrol vapors have dissipated.
Replace all fuel tanks and container caps securely.
Before tipping the lawn mower to maintain the blade or drain oil, remove fuel from tank.
WARNING: Never fill fuel tank indoors, with engine running or until the engine has been allowed to cool
for at least 15 minutes after running.
7.2 TO START ENGINE AND ENGAGE BLADE
7.2.1 STARTING MANUALLY (For DYM1676CD-3/DYM1678D-3/DYM162002)
1. The unit is equipped with a rubber boot over the end of the spark plug, make certain the metal loop on the
end of the spark plug wire (inside the rubber boot) is fastened securely over the metal tip on the spark plug.
2. Before starting engine, please turn the fuel switch to the "
DYM1678D-3)
3. When starting cool engine, turn throttle choke lever to "
When starting warm engine and operating, turn throttle chock lever to "
4. Standing behind the unit, grasp the brake control handle and hold it against the upper handle as shown in
Fig.10C.
5. Grasp the starter handle as shown Fig.10C and pull up rapidly. Return it slowly to the rope guide bolt after
engine starts.
Release the brake control handle to stop the engine and blade.
6. When you finish the job of mowing each time, please turn the fuel lock to the"
DYM1678D-3).
"position. (Fig.10A )(Only for
" position. (Fig.10B)
"position. (Fig.10B)
14
". (Fig.10D)(Only for