Publicidad
Idiomas disponibles
Idiomas disponibles
Part 1: Lifting and Jacking the Vehicle:
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle
and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are
being removed and strap the vehicle to the hoist.
Warning: To help avoid personal injury, always use jack stands when you are working on or under any vehicle that is supported
only by a jack.
Caution: When you are jacking or lifting a vehicle at the frame side rails or other prescribed lift points, be certain that the
lift pads do not contact the catalytic converter, the brake pipes or the fuel lines. If such contact occurs, vehicle damage or
unsatisfactory vehicle performance may result.
Before you begin any lifting procedure, be sure the vehicle is on a clean, hard, level surface. Be sure all the lifting equipment
meets weight standards and is in good working order. Be sure all the vehicle loads are equally distributed and secure. If you are
only supporting the vehicle at the frame side rails, make sure the lifting equipment does not put too much stress on or weaken
the frame side rails.
If you use any other lifting methods than those called out, take special care not to damage the fuel tanks, the exhaust system or
the underbody.
Caution: When you are jacking the vehicle at the front locations, be certain that the jack or the jack lift pad does not contact
the front fascia, front fascia air dam, or the front fenders. If such contact occurs, vehicle damage may result. When jacking at
selected front locations additional clearance may be required for the jacking points.
It may be necessary to put the vehicle with ground effects on low ramps to allow the lift arms to fit under the vehicle and provide
necessary clearance for the installed rocker moldings.
Corvette Carbon Fiber Underbody Brace Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
23385707
REV 29SE15
PART NO.
DATE
16AP15
Initial Release - David Stchur
29SE15
Revision - Shawn Meagher
2
SHEET
REVISION
12
OF
AUTH
2229836
2229836
Publicidad
