Publicidad
Idiomas disponibles
Idiomas disponibles
Minimum Ramp Dimensions
•
Height: 76 mm (3 in)
•
Width: 304 mm (12 in)
Vehicle Lifting and Jacking Locations
(1) Preferred Vehicle Jacking Locations
(2) Optional Vehicle Jacking Locations
(3) Frame Contact Hoist Locations, Optional Vehicle Jacking Locations
(4) Suspension Contact Hoist Locations
Part 2: Brace Removal & New Brace Installation:
1. Remove bolts (1) in rear braces and remove braces (2) you can discard bolts.
2. IMPORTANT: Apply a coating of RTV Silicone compound to the entire interface surfaces on the braces (the surface areas
where the brace will come into contact with the frame). Do this on all 4 braces being installed.
3. Place new carbon fiber braces p/n 23125045 in place of braces removed and tighten new bolts p/n 11589274 to
100 N*m (74 lb ft).
Corvette Carbon Fiber Underbody Brace Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
23385707
REV 29SE15
PART NO.
DATE
16AP15
Initial Release - David Stchur
29SE15
Revision - Shawn Meagher
3
SHEET
REVISION
12
OF
AUTH
2229836
2229836
Publicidad
