Descargar Imprimir esta página

Using The Device; Answering A Call - Vimar ETVAX 40510 Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 38
7" Due Fili Plus porter switchboard
6.
Numbering plan: natural, 4 digits (vertical installation only) or 8 digits (default: natural).
7.
Horizontal or vertical installation (default: vertical).
8.
Reset of all parameters to default factory settings
9.
Installer PIN (default: 1234). (Reserved for installer)
10. Keyboard unlock PIN (default: 0000)
11. Events list procedures. (Reserved for technical support)
12. System information. (Reserved for technical support)

USING THE DEVICE

Call to indoor unit or switchboard
To call:
• Enter the number on the keyboard, then lift the handset or press
• Select the entry in the contacts list (see sub-section "Search contacts list" below), then lift the handset or press
.
The call can be ended using the key
Wait for the call to be answered. The conversation can then be ended as described above.
Incoming call (from speech unit, indoor unit or switchboard)
In the event of an incoming call, before answering you can:
• Mute the chime (for the current call only) by pressing the key
• Reject the call by pressing the key
• While it is ringing, adjust the chime level using the
• In the event of a video call, adjust the brightness and contrast. Press and hold key
select the parameter you wish to adjust: chime level, brightness or contrast. Selection is cyclical. Then use keys
and
to increase or decrease the level.
Information relating to the caller appears in the bottom right-hand corner:

Answering a call

To answer a call from a speech unit, indoor unit or switchboard:
• When the handset has been hung up, carry out one of the following actions:
o Lift the handset: the conversation will be enabled for the handset
o Press the key
• With the handset lifted, carry out one of the following actions:
o Replace and then lift the handset again: the conversation will be enabled for the handset
o Press the key
After answering, lift the handset to switch from hands-free to handset mode. Conversely, to switch from handset to hands-
free mode: press and hold the key
20
, or if the handset is lifted, you can also hang up.
.
: the conversation will be enabled in hands-free mode
: the conversation will be enabled in hands-free mode
, hang up the handset and then release the hands-free key.
EN
.
for 0.5 seconds.
and
keys.
for 0.5 seconds to

Publicidad

loading

Este manual también es adecuado para:

Due fili plus 40510