Test-Fit Close Tolerance Bolts; Package Contents; Base Assembly - SPALDING M7A1021 Manual Del Usuario

Test-Fit Close Tolerance Bolts

Test-Fit Close Tolerance Bolts
To ensure optimal playability of the backboard system, a close tolerance fit between the elevator components and
hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates.
Carefully rock them in a circular motion to remove any excess paint from holes if necessary.
Not all items pictured are included with every model.

Package Contents

Check the contents of each kit and other parts to ensure all components are present. Keep the kit hardware in the
labeled bag as they will be used in different steps of assembly.
See "Parts List" on page 29 for a complete list of replacement part numbers.

BASE ASSEMBLY

#24
#1
#10
1 Base (x1)
4 Top Pole (x1)
10 Tank Strut (x2)
24 Cap, Base (x1)
* Parts may not be included with all models
NOTE
#45
#23
#2
#19
2 Wheel, Axle (x1)
5 Middle Pole (x1)
19 Wheel Bracket (x1)
45 Gasket, Screw Cap (x1)
4
#3
#4
#48
3 Wheel, 4" (x2)
6 Bottom Pole (x1)
23 Cap, Base, Screw Cap, Large, 5.5" Dia. (x1)
48 Pole Pad (x1)*
#5 #6