Publicidad
Idiomas disponibles
Idiomas disponibles
• Insert the plug into the electrical
socket. When the power supply
base is connected to the electrical
socket, the red pilot lamp on the
power supply base will light up
.
HOW TO MAKE COFFEE
You can now make coffee in two
ways: manually, or by programming
the digital timer.
How to make coffee manually
• Press the ON/OFF
the power supply base emits a
steady BEEP for 5 seconds and
the coffee cycle begins. Both the
red pilot lamp on the base of the
espresso maker
and the green
pilot lamp on the power supply
base
light up, and the word
PROGRAM (
PROGRAM
the display.
• Attention: When the espresso
maker is heating, there may be
a slight noise created by steam
rising through the central column
in the upper body. This is normal,
as happens with regular espresso
pots, and means that the espresso
maker is heating rapidly.
• When the coffee is ready, the
power supply base emits a long
BEEP and both the red pilot lamp
on the base of the espresso maker
and the green pilot lamp on the
power supply base switch off.
(fig. 8)
BEEP
P
CLOCK
+
• To interrupt the coffee cycle, you
can lift the espresso maker off the
power supply base ( which will
emit a long BEEP) or press the
ON/OFF
.
Pantone 415
button:
) appears on
O/I
Fig. 8
16
To resume the coffee cycle, place
the espresso maker back on the
power supply base and press the
button again. We do
ON/OFF
not advise this procedure, because
the quality of the coffee may not be
satisfactory.
How to make coffee by
programming the digital timer
This espresso maker has a digital
timer that automatically turns it on
at the set time.
• Press the PROGRAM ,
button once: digital timer
mode activates and the word
PROGRAM (
) flashes. The
PROGRAM
word CLOCK (
) disappears.
CLOCK
• Press the "+"
or "–"
to programme the digital timer
(see How to set the time).
• After you have programmed the
timer, you can confirm in two
ways:
- by pressing the ON/OFF
button: the display returns to
normal clock mode and shows the
set time. The words PROGRAM
(
) and CLOCK (
PROGRAM
active, indicating that a starting
time has been set. (fig. 9)
P
O/I
CLOCK
PROGRAM
+
- by not pressing any button for 5
sec: the new setting is considered
confirmed and the display returns
to normal clock mode. The
words PROGRAM (
PROGRAM
and CLOCK (
) are active,
CLOCK
indicating that a starting time has
been set.
At the set time:
• The power supply base emits a
steady BEEP for 5 seconds and
the coffee cycle begins. Both the
red pilot lamp on the base of the
buttons
:
) are
CLOCK
Fig. 9
)
Panton
Publicidad
