Rear Panel - Tripp-Lite SmartOnline Manual Del Usuario

Basic Operation
"REPLACE BATT" LED: This red light will illuminate constantly and the UPS
alarm will beep every 2 seconds if your UPS's microprocessor detects a
battery fault or if your UPS fails the automatic self-test (after you turn your
UPS ON) and the UPS battery is less than fully charged. Let the UPS
system charge for at least 12 hours and perform a self test using the "ON/
TEST Button" as described on page 7. If the light continues to stay on,
contact Tripp Lite for service.

Rear Panel

Accessory Slot: Remove the small cover panel from this slot to use
optional accessories to remotely monitor and control your UPS. Contact
Tripp Lite Customer Support at (773) 869-1234 for more information,
including a list of available SNMP , network management and connectivity
products.
External Battery Pack Connector (configuration varies by model): Use
to connect optional Tripp Lite Battery Packs for additional runtime. Contact
Tripp Lite Customer Support at (773) 869-1234 for the appropriate Tripp
Lite battery pack to connect. Refer to instructions available with the Battery
Pack for complete connection information and safety warnings.
Fan: The fan cools the UPS's internal components. It is always on when
line power is present.
Input Circuit Breaker Switch: This resettable breaker prevents high input
current from damaging the UPS or the attached load. If this breaker trips,
make sure your UPS is connected to AC power of the proper voltage before
resetting the circuit breaker by pushing the breaker switch in.
Ground Screw: Use this to connect any equipment that requires a chassis
ground.
Output Circuit Breakers Switches (Select Models Only): These
resettable circuit breakers protect your UPS from output overload. If one or
both breakers trip, remove some of the load on the circuit(s) and allow the
UPS to cool before pressing the breaker switch(es) in to reset.
Input Cord: This permanently attached power cord connects your UPS to a
power outlet.
10
201102199 93-2471.indb 10 3/30/2011 9:14:04 AM