Electrical Connection - Ravelli HR EVO 300 SMART Manual De Uso Y Mantenimiento

Electrical connection

The plug of the boiler's power cable must only be connected after the installation and assembly has been completed of the
appliance, and must remain accessible after installation.
To make the electrical connection, proceed as described below:
First connect the power cable to the plug on the back of the boiler and then to a wall socket.
Supply power to the boiler by turning the switch to position (I).
��
⚠
When the boiler is not in use, it is advisable to disconnect the power cable.
⚠
Take care that the power cord (and any other cables outside the equipment) do not come into contact with hot surfaces.
⚠
Ensure that the electrical system is grounded.
Make sure the electrical system and the sockets are suitable for the maximum absorption of the unit, specified on the label
⚠
and in this manual.
For direct connection to the mains, it is necessary to provide a device that ensures disconnection from the mains, with a
contact opening distance that allows complete disconnection under the conditions of over-voltage category III, in accordance
⚠
with installation rules
If the power supply cable is damaged, it must be replaced by the manufacturer or its technical assistance service or in any
⚠
case by a person with similar qualifications, so as to prevent any risk.
It is recommended that authorized personnel pay special attention to the electrical connections after any work on the product.
Use and maintenance manual HR EVO Smart
Switch
Power plug
Fuse
EN
Rev.1 08/09/2021
Pag.31