Emptying The Water Reservoir; Cleaning The Air Intake Grille; Cleaning The Drum - Zanussi ZTE 220 Instrucciones Para El Uso

125980900.qxp 2005-01-05 15:20
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser cabinet
and in the inner part of the small door with a damp
cloth.
Re-fit the condenser, turn the red stops upwards and
close the door.
Important! Do not use pointed objects or utensils to
clean the spaces between the plates, as this could
damage the condenser and make it permeable.
Do not use this appliance if the condenser
has not been fitted.

Emptying the water reservoir

Water extracted from the laundry condenses inside
the machine and is collected in a reservoir.
The reservoir must be emptied after each drying
cycle to ensure efficient operation when the machine
is next used.
If this is not done a safety device trips: pilot light
on the control panel comes on and the programme
stops, leaving the laundry damp. The buzzer will
sound for 1 minute.
The reservoir can be emptied even in the middle of a
programme.
Proceed as follows:
•
Pull out the reservoir
•
Turn it upside down and let water flow down
•
Re-fit the reservoir
P1156
The reservoir must be re-inserted correctly.
After inserting the reservoir the START-button
has to be depressed again to allow the programme
to continue.
Handy tip: The condensed water may be used in a
steam iron or to top up a battery, etc. In this case it
must be filtered (e.g. through a coffee filter).
Page 12
P1157
12

Cleaning the air intake grille

Using a vacuum cleaner remove the fluff from the air
intake grille at the back of the appliance.
P1162

Cleaning the drum

When your laundry does not reach the desired
degree of dryness, in other words, when it turns out
either too dry or too damp, we advise you to clean
the inside of the drum with a cloth soaked with
vinegar.
This will eliminate the slight patina that has formed in
the drum (due to residues of detergent and softeners
used in the washing, and to the lime contained in the
water), which prevents the probes from detecting the
correct degree of dryness.