Bosch GTA 2600 Professional Manual Original página 17

OBJ_BUCH-843-003.book Page 17 Friday, May 7, 2010 12:39 PM
Preparing the Saw Stand
Preparing the Attachment Sets (see figure C)
for GCM 10 xx, GCM 12 xx, GTM 12
– Insert one carriage bolt 12 each through as-
sembly-sliding plate 17 and 18.
– Position assembly-sliding plate 17 with the
carriage bolt in the rear slot of the attach-
ment set.
– Position assembly-sliding plate 18 with the
carriage bolt in the front slot of the attach-
ment set.
– Repeat the worksteps with the second at-
tachment set.
for GCM 8 S, GCM 8 SJ, GCM 800 S
– Insert one carriage bolt 12 through assembly-
sliding plate 17 and one carriage bolt 10
through assembly-sliding plate 18.
– Position assembly-sliding plate 17 with the
carriage bolt in the rear slot of the attach-
ment set.
– Position assembly-sliding plate 18 with the
carriage bolt in the front slot of the attach-
ment set and secure the carriage bolt with
the nut locking device 15 against falling out.
– Repeat the worksteps with the second at-
tachment set.
Fastening the Power Tool to the Attachment
Sets (see figure D)
– Position the power tool in the transport posi-
tion. Notes on the transport position are giv-
en in the operating instructions of the re-
spective power tool.
– Raise one side of the power tool and position
the carriage bolts of the attachment set at
the correct distance to the mounting holes of
the power tool.
Note: Power tools with off-set mounting holes
can also be fastened with help of the slot in the
assembly-sliding plate 18 and the lateral slot in
the attachment set 6.
Bosch Power Tools
– Lower the power tool onto the carriage bolts
and loosely screw the attachment set and
the power tool together with the washers 13,
lock washers 14 and nuts 16.
– Screw the locking knob 8 into the corre-
sponding hole of the attachment set 6.
– Repeat the worksteps with the second at-
tachment set.
Fastening the Attachment Sets with the Power
Tool onto the Saw Stand (see figures E1 – E2)
– Align both attachment sets parallel to each
other.
– Position the power tool centred on the saw
stand in the sequence shown. Firstly, allow
the rounded-off part of the attachment sets
to rest against the front rail (1), then slowly
and carefully lower the power tool (2) until it
is seated securely on the rear rail.
– If required, move the power tool on the at-
tachment sets 6 so that the weight is posi-
tioned centrally on the saw stand.
– Now, firmly tighten the nuts 16 for final fas-
tening of the power tool.
– Afterwards, firmly tighten both locking knobs
8 of the attachment sets.
English | 17
1 609 929 W87 | (7.5.10)