Checking The Charge Status Of The Rechargeable Battery; Charging The Battery; Used Batteries; Assembling Instructions - Grizzly AHS 1845 T Lion Traducción Del Manual De Instrucciones Original

GB
Checking the charge status of
the rechargeable battery
The state of charge display (12b) signalis-
es the state of charge of the battery (12).
1. Press the button (12c) on the
battery (12).
The state of charge of the bat-
tery is displayed by illuminating
the appropriate LED lights of the
state of charge display (12b).
2. Charge the battery if the last
LED light of state of charge dis-
play (12b) changes from green
to red.

Charging the battery

Allow a freshly charged battery (11)
to cool down for approx. 15 min-
utes before inserting it into the bat-
tery charger (22).
LED lights:
• The LED lights of the state of charge
display ( 12b) of the battery (12)
flashes red if you have inserted a hot
battery into the battery charger (18).
1. If necessary, remove the battery
(12) from the device.
2. Slide the rechargeable battery
(12) onto the charger (18). It
locks into place audibly.
3. Plug the charger (18) into an
electrical outlet.
4. After the charging process, dis-
connect the charger (18) from
the mains supply.
5. Press the release keys (12a) on
the battery (12) and pull the bat-
tery out of the charger (18).
30

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Assembling instructions

Pull out the power plug before car-
rying out any work on the equip-
ment.
If the equipment pipes are not
plugged together and screwed
correctly then the equipment
cannot be switched on.
Operation is prevented by a
safety switch!
Use only original parts.
Assembling the Equipment
1. Interlock the end of the hex-
agonal aluminium pipe of the
telescopic arm (7) and the end of
the arm below the cutting head
(2) up to the stop. Whilst inter-
locking the two, ensure that the
nose (7a) of the hexagonal alu-
minium pipe fits into the nut (2a)
at the end of the arm (see small
image).
2. Fasten both parts using the
screw sleeve (6) .