Atlas Copco G2420 Manual De Producto página 18

Service
Assembling the belt sander
1. Put the motor assembly and the felt (29) into the motor housing.
2. Put the gasket (19) back in position on the motor housing.
3. Apply a few drops of thread locker on the cap screws (16).
4. Attach the motor housing cap (18) to the motor housing with the cap
screws (16) and the washers (17). Tighten to 1.96 - 2.45 Nm.
5. Put the drive pulley (32) in position on the rotor and turn carefully the mo-
tor to tighten it.
Make sure that the rotor turns smoothly.
6. Push the arm holder (6) until it locks.
7. Attach a sanding belt.
8. Push the stopper (4) to release the arm holder (6).
18
EN
© Atlas Copco Industrial Technique AB - 9839 0458 00
G2420