Kohler K-1170 Guia De Instalacion página 2

Roughing-In
11-3/4"
(29.8cm)
33" (83.8cm)
20-1/8"
(51.1cm)
1-1/2" O.D.
Product Information
Drop-in whirlpool
Required accessories:
Jet trim kit
Fixture*: basin area
Bathing 42" (106.7cm) x
well 27" (68.6cm)
water depth
To overflow 16" (40.6cm)
* Approximate measurements for comparison only.
Pump Heater
1.5 HP 1.5 kW
Required Electrical Service
Dedicated circuit required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker
(ELCB):
Pump/control
B
1024309-1-
K-1170-H2
5-1/4" (13.3cm)
66" (167.6cm)
3" (7.6cm)
1-1/16" (2.7cm)
K-1170-H2
K-9698
top area
54" (137.2cm) x
30" (76.2cm)
capacity
81 gal. (306.6L)
Voltage Frequency
240 V 50/60 Hz
220-240 V, 20 A, 50/60 Hz
No change in measurements if connected with drain illustrated.
(K-7161-AF or K-7161M-AF)
Drop-in cut-out
Minimum access panel:
Pump/control
PUMP/CONTROL ACCESS
22"
(55.9cm)
Notes
Install this product according to the installation guide.
shown
Floor support under whirlpool must provide for a minimum of
1400 lbs (635kg).
Hot water supply should be 70% of capacity or greater. Installations
will vary.
weight
If installing a rim mount faucet, make sure there is no interference
134 lbs.
with drain overflow and circulating system before drilling any
(60.8kg)
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This whirlpool is designed for drop-in installation only. It is not suited
for use in a three wall alcove with an overhead shower.
Fixture conforms to ANSI Standard Z124.1. All dimensions are
nominal.
Amperage
11 A
2
64-1/2" (163.8cm) x 40-1/2" (102.9cm)
34" (86.4cm) W x required
15" (38.1cm) H
42" (106.7cm)
2-7/8" (7.3cm)
3" (7.6cm)
Kohler Co.