Technical Data; Noise Information; Vibration Information - KRESS KUW58.1 Manual Del Usuario

TECHNICAL DATA

Type Designation KUW58.1 (W58 - designation
of machinery, representative of Sonicrafter)
Rated voltage
Power input
Oscillation speed
Oscillation angle
Protection class
Tool weight (without power
cable)

NOISE INFORMATION

A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined
according to EN 62841:
Typical weighted
vibration
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
220-240V~50Hz
480W
11000-20000/min
5°
/II
1.63kg
L =80.5 dB(A)
pA
3 dB(A)
L =91.5 dB(A)
wA
3 dB(A)
Vibration emission value
a =5.23 m/s²
h, P
Uncertainty K = 1.5 m/s²
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
35mm End Cut Blade UI (KA0782)
35mm Precision End Cut Blade UI (KA0781)
80mm HSS semicircle saw blade (KA0760)
Sanding pad (KA0920)
40# Sanding Sheet (perforated)
80# Sanding Sheet (perforated)
120# Sanding Sheet (perforated)
Rigid Scraping Blade (KA0820)
35mm Universal end cut blade (KA0780)
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The power tool is intended for sawing and remodeling
wooden materials, plastic, plaster, non-ferrous metals
and fasteners (e.g. nails and clamps) as well as for
working on soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working close to
edges and for flush cutting.
Assembly and Operation
ACTION
Mounting Accessories
Mounting the Sanding Sheet
Operating the On/Off Switch
Using the Variable Speed Dial
The Variable Speed Dial can be used to set the
1
1
1
1
2
2
2
1
1
FIGURE
See Fig. A-C
See Fig. D
See Fig. E
See Fig. F
7
EN