Before Use; Package Contents And Transport Inspection; Set-Up Location Requirements - Silvercrest SKD 2300 D4 Instrucciones De Uso

Before use

Package contents and transport inspection

The appliance is supplied with the following components as standard:
▯ 1 convection heater SKD 2300 D4
▯ 1 remote control
▯ 1 CR2032 button cell
▯ 2 feet
▯ 4 screws for the feet
▯ These operating instructions
NOTE
► Check the package for completeness and for signs of visible damage.
► If any items are missing or damaged as a result of defective packaging or insufficient
care during transportation, contact the Service hotline (see the chapter Service).

Set-up location requirements

For safe and trouble-free operation of the appliance, the set-up location must fulfil the
following requirements:
■ The appliance may only be operated in a vertical position and fully assembled.
■ The appliance must be placed on a firm, flat and horizontal surface.
■ The minimum clearances between the housing and other objects must be maintai-
ned: 10 cm at the sides, 30 cm above and 50 cm in front.
■ Ensure that air can always enter and escape freely. Otherwise, there could be a
heat build-up in the appliance.
■ Do not place the appliance in a hot, wet or extremely moist environment or in the
vicinity of flammable materials.
■ The mains power socket must be easily accessible so that the power cable can
be easily disconnected in an emergency.
DANGER
Fire risk due to contact with materials!
There is a risk of fire if the heating elements come into contact with
flammable materials!
► Do not place the appliance in the vicinity of curtains and other flammable materials.
► Do not allow flammable materials (i.e. textiles) to come into contact with the
appliance.
► Do not cover the appliance.
│ GB │ IE
■ 28 SKD 2300 D4